Brampton Assembly Plant and Brampton Satellite Stamping Plant

2000 Williams Pkwy E
Brampton, ON L6S, Canada
  • This information has been verified good Verified Good
  • This information has been verified bad Verified Bad
  • This information has unverified Unverified

Additional Information

General Information

Chrysler - Brampton Assembly Plant and Brampton Satellite Stamping Plant
Latitude / Longitude
Latitude = 43.748917
Longitude = -79.714887

Latest Company News

Maserati makes grand plans for revival at its 100th birthday party

Wed, 20 Aug 2014 13:58:45 -0700
Slip-sliding around Mazda Raceway Laguna Seca with Derek Hill in the world’s last Maserati Tipo 151 – a vintage honey that tore through LeMans in the early ‘60s – it’s possible to imagine that Maserati’s glory days were all in the past. But seeing the alluring Alfieri concept car unveiled for North America, it’s clear that Maserati has more in mind than being a nostalgia act.

read more

Contact Information

Main Contact Person - Jodi Tinson

Other Information

This company is not affiliated with another location
Brampton Assembly Plant
269 Acres
Chrysler 300, Dodge Charger, Dodge Challenger
2,723 (2,558 hourly; 165 salaried) on two shifts
20.4 Miles
Floor Space
2.95 Million Sq. Ft.
Plant History
Facility was built in 1986 and acquired by Chrysler Corporation with purchase of American Motors Corporation (AMC) in August 1987. The facility began production of LH vehicles (Chrysler Concorde, Dodge Intrepid and Eagle Vision) in June 1992. Production of the next generation Chrysler Concorde and Dodge Intrepid began in September 1997, followed by the Chrysler LHS and 300M in April 1998. Production of rear-wheel drive vehicles started at the beginning of 2004 with the launch of the Chrysler 300 and Dodge Magnum. Production of the Dodge Charger was launched in early 2005. Dodge Magnum production was discontinued in late 2007. The all-new 2009 Dodge Challenger SRT8 launched production in May 2008, with the Dodge Challenger following in August 2008.
Brampton Satellite Stamping Plant
96 inner and outer body stampings: doors, hoods, decklids, quarter panels and roofs
5 automatic transfer presses, 1 blanking line, 90 die sets (4-minute die changes)
Included in Assembly Plant total listed above
Material Handling
Automatic guided vehicles (AGVs) deliver blanks to press lines
Automatic sheet metal storage and retrieval system. 3,600 storage containers
Floor Space
230,000 Sq. Ft.
Plant History
Satellite stamping facility was completed and production started in December 1991.